Assembly Guide

The Grimalkin Sorcerer’s clear spell pieces may require reshaping, so be sure to do that first to make assembling easier. See instructions here.

If you wish to paint the elements separately before assembling, you should do so before applying any adhesive!

Apply a small amount of adhesive to the face up palm of the miniature’s left hand. Now place the clear flame spell effect gently into the palm and hold in position until the adhesive dries. It may be easier to use tweezers to place and hold the flame in place.

NOTE: You can place the flame in any direction or mimic the rotating image at the top of this page.

The Chellon Wizard’s clear spell pieces may require reshaping, so be sure to do that first to make assembling easier. See instructions here.

If you wish to paint the elements separately before assembling, you should do so before applying any adhesive!

NOTE: In the image below, the top spell effect has a 90 degree angle near the peg that slots into the top of the sorcerer’s arm. The peg will fit into the arm slot one way, so do not attempt to force it as you may break the miniature or spell effect. This top lightning spell effect can be reshaped by rotating the peg arm just past the 90 degree angle so as to avoid touching the miniature’s arm/hand like example B below. Or you can just leave the top lightning spell effect as it is and gently place the smaller arc to rest on the hand after putting it in the slot as would be similar to example A.

It is recommended to place the top lighting effect in the arm slot before adding adhesive to get an idea of whether or not you wish to reshape it.

Add a small amount of adhesive to each peg and gently place into the slots on the arm and sleeve. Each lightning spell effect may require you to hold them in place while they dry as to avoid the spell effect shifting or falling.